Orange Glass Ring

IMG_9868.jpg
IMG_9866.jpg
IMG_9870.jpg
IMG_9884.jpg
IMG_9865.jpg
IMG_9881.jpg
IMG_9888.jpg
IMG_9871.jpg
IMG_9868.jpg
IMG_9866.jpg
IMG_9870.jpg
IMG_9884.jpg
IMG_9865.jpg
IMG_9881.jpg
IMG_9888.jpg
IMG_9871.jpg

Orange Glass Ring

from 60.00

For this design, I first cut out the round outline of the ring’s base plate from a thick sheet of metal and stamped the back of it with my maker's mark. I hand-filed the edge to give it a smooth look. I measured the stone’s height as well as its perimeter to work on the setting. I sawed out a strip of metal to a length that, snugly, fit around the stone. I molded the exact shape of the stone with the strip and soldered it closed. I, then, soldered the setting onto the ring’s base plate. The rope-like detail that surrounds the stone I created by, carefully, braiding two thin-gauged wires and then incorporating a thicker-gauged wire into the mix to bring about this contrasting rope-like design. I molded this embellishment so that it followed the perimeter of the stone and soldered it to the ring. As I soldered the it onto the base of the ring, I simultaneously soldered it closed, being careful to make the join seamless. This usually takes an extra soldering step to fill in any gaps left in the join during the closing of the rope-like detail. For the ring shank, I cut out a thick piece of shank stock, according to the desired ring size. I hand-filed both ends of the metal so that they fit, flushly, together and soldered the ring closed. Then, I hammered the ring shank against a steel mandrel in order to shape it and bring the ring to the desired size. I soldered the ring and setting together, while assuring that it was centered. I tumbled the piece, for a substantial amount of time, until the perfect amount of strength and additional shine was reached. In the next step, I applied a darkening solution to blacken the design and bring out its unique beauty. During this process, I blackened the entire piece so that the solution seeped into every nook and cranny. I, then, thoroughly hand-polished the ring, making sure to leave any crevices untouched so that the newly-darkened details stood out against the high-polished finish of the rope-like embellishment. Finally, I inserted the stone into its setting and, carefully, molded the metal tightly around the stone in order to secure it in place.

Although it is a lengthy and messy process, the beautiful results makes it all worthwhile. As seen in the photos, the rope-style detail that seamlessly surrounds the bright orange and pretty stone makes the overall design chic and modern.  


STONE: 
*~ glass ~*


COLOR: 
*~ orange ~*


METAL: 
*~ brass / sterling silver ~*


RING SIZE:
*~ 4" - 12" ~*


STONE SIZE: 
*~ 7mm ~*


RING FACE SIZE:
*~ 15mm ~*


{ given the handcrafted nature of this ring, your creation may vary
slightly from the ring pictured } 

In order to show their maximum detail, all rings are photographed at close-up range. Therefore, they may seem larger than they actually are. Please refer to item description above for size details.

This item is custom-made, therefore non-refundable. I try my best to be accurate in my item descriptions. However, if I fail to do so, and your item is not as described, I will honor a return/refund.

Metal:
Quantity:
Add To Cart